Cable
1.13
End A
F FEMALE
$2.00
End B
MCX MALE
$1.00
1.13 — F FEMALE to MCX MALE
Custom 1.13 cable assembly with F FEMALE and MCX MALE connectors. Every cable is hand-assembled, tested, and ships free.
| Length | Price | |
|---|---|---|
| 1 ft | $6.20 | |
| 6 ft | $7.80 |
Specs Summary
About This Assembly
1.13 Cable
1.13mm coaxial cable is an ultra-miniature 50-ohm cable used primarily for internal RF wiring in compact wireless devices such as laptops, tablets, and embedded modules. Its extremely small 1.13mm outer diameter allows it to pass through tight spaces inside consumer electronics, connecting antennas to WiFi or cellular modules with minimal signal loss over short distances.
F Connector
The F connector is a low-cost threaded coaxial connector used almost exclusively in cable TV, satellite, and over-the-air broadcast applications. It uses the center conductor of RG-6 or RG-59 cable as the pin, which simplifies termination and reduces cost. F connectors are found on cable modems, satellite receivers, TV tuners, and distribution amplifiers.
MCX Connector
MCX (Micro Coaxial) is a snap-on RF connector approximately 30% smaller than SMB, designed for compact equipment requiring frequent connections in a small footprint. Rated to 6 GHz, MCX is commonly used in GPS receivers, automotive telematics modules, handheld communication devices, and compact measurement instruments.
Common Applications
This F and MCX cable assembly is well suited for internal WiFi and cellular module antenna connections in laptops and tablets. The combination of reliable F and MCX connectors and custom-cut cable length makes it a practical choice for both field installations and bench setups. Every assembly is hand-terminated, continuity tested, and ships free within the USA.
