Cable
LMR100 Times
End A
F FEMALE
End B
N MALE
Specs Summary
100 ft LMR100 Times — F FEMALE to N MALE
LMR100 Times cable assembly, 100 feet, with F FEMALE and N MALE connectors. Hand-assembled, tested, and ships free within the US.
100 ft — F FEMALE / N MALE
$116.99
Free shipping • In stock
Other lengths:
Signal Loss — 100 ft
Approximate insertion loss for this 100 ft LMR100 Times assembly at common RF frequencies.
| Frequency | Loss / 100 ft | Loss — 100 ft |
|---|---|---|
| 100 MHz | 5.1 dB | 5.1 dB |
| 450 MHz | 11.2 dB | 11.2 dB |
| 900 MHz | 16.2 dB | 16.2 dB |
| 1.8 GHz | 23.8 dB | 23.8 dB |
| 2.4 GHz | 27.8 dB | 27.8 dB |
| 5.8 GHz | 46 dB | 46 dB |
About This Assembly
LMR100 Times Cable
LMR-100A is a Times Microwave 50-ohm flexible coaxial cable with a 0.100" outer diameter, delivering significantly lower signal loss than RG-174 or RG-178 at the same form factor. Its foil-plus-braid shield offers 40 dB shielding effectiveness. A popular upgrade for short antenna pigtails and module connections in WiFi, cellular, and GPS applications.
F Connector
The F connector is a low-cost threaded coaxial connector used almost exclusively in cable TV, satellite, and over-the-air broadcast applications. It uses the center conductor of RG-6 or RG-59 cable as the pin, which simplifies termination and reduces cost. F connectors are found on cable modems, satellite receivers, TV tuners, and distribution amplifiers.
N Connector
Type N is a threaded RF connector rated from DC to 18 GHz with a durable weatherproof design, making it the preferred interface for outdoor antenna installations, cellular base stations, and commercial wireless infrastructure. Its larger size compared to SMA allows higher power handling and the threaded coupling resists vibration, making it suitable for mobile and fixed outdoor applications.
Common Applications
This F and N cable assembly is well suited for short antenna pigtails, module-to-antenna connections, and compact RF assemblies. The combination of reliable F and N connectors and custom-cut cable length makes it a practical choice for both field installations and bench setups. Every assembly is hand-terminated, continuity tested, and ships free within the USA.
Frequently Asked Questions
Is this cable hand-assembled in the USA?
Yes. Every CoaxRF cable assembly is hand-terminated and continuity tested at our US facility before shipping. We do not drop-ship pre-made cables from overseas — each cable is built to order.
Can I order a different length than 100 ft?
Yes. This page is for the 100 ft assembly. Use the length buttons above to select a different standard length, or use the Cable Builder for any custom length.
How much signal loss will I see with this 100 ft cable?
At 1800 MHz, LMR100 Times loses approximately 23.8 dB per 100 ft. This 100 ft assembly will have roughly 23.8 dB of insertion loss at that frequency. See the signal loss table for all frequency points.
What is the maximum frequency for this assembly?
This assembly is rated DC – 2 GHz. The effective frequency limit is set by the lowest-rated component — either the cable or one of the connectors. Both F FEMALE and N MALE connectors must be within spec at your target frequency.
What is your return policy?
We accept returns within 30 days of delivery. Custom-length cables are accepted as long as they are in original condition. Contact us and we will provide a prepaid return label at no charge.
