LMR100 Times — F FEMALE to PL259 UHF Male
Custom low loss LMR100 Times RF coaxial cable assembly with F FEMALE and PL259 UHF Male connectors.
Cable
LMR100 Times
End A
F FEMALE
End B
PL259 UHF Male
Specs Summary
Made in USA
Assembled and tested in-house
Free Shipping
Fast, reliable delivery
Tested & Verified
Every cable tested before shipping
Easy Returns
30-day hassle-free returns
Need help choosing a cable?
Our RF experts are here to help you get the right fit.
Call an RF expert
1-661-200-0771
Email us
sales@wifiexpert.us
Need a custom cable?
Build your exact cable in seconds using our Cable Builder.
About This Assembly
Specs Summary
LMR100 Times Cable
LMR-100A is a Times Microwave 50-ohm flexible coaxial cable with a 0.100" outer diameter, delivering significantly lower signal loss than RG-174 or RG-178 at the same form factor. Its foil-plus-braid shield offers 40 dB shielding effectiveness. A popular upgrade for short antenna pigtails and module connections in WiFi, cellular, and GPS applications.
F Connector
The F connector is a low-cost threaded coaxial connector used almost exclusively in cable TV, satellite, and over-the-air broadcast applications. It uses the center conductor of RG-6 or RG-59 cable as the pin, which simplifies termination and reduces cost. F connectors are found on cable modems, satellite receivers, TV tuners, and distribution amplifiers.
UHF Connector
The UHF connector (also known as PL-259 male / SO-239 female) is a large, low-cost RF connector designed in the 1930s for HF and VHF frequencies. Despite its name, its practical usable range is below 300 MHz due to its non-constant impedance design. It remains extremely popular in amateur radio (HF through VHF), CB radio, and marine radio applications.
Common Applications
This F and UHF cable assembly is well suited for short antenna pigtails, module-to-antenna connections, and compact RF assemblies. The combination of reliable F and UHF connectors and custom-cut cable length makes it a practical choice for both field installations and bench setups. Every assembly is hand-terminated, continuity tested, and ships free within the USA.
LMR100 Times Signal Loss
Approximate attenuation at common RF frequencies.
| Frequency | Loss / 100 ft | Loss / ft |
|---|---|---|
| 100 MHz | 5.1 dB | 0.051 dB |
| 450 MHz | 11.2 dB | 0.112 dB |
| 900 MHz | 16.2 dB | 0.162 dB |
| 1.8 GHz | 23.8 dB | 0.238 dB |
| 2.4 GHz | 27.8 dB | 0.278 dB |
| 5.8 GHz | 46 dB | 0.46 dB |
Frequently Asked Questions
What is LMR100 Times coaxial cable used for?
LMR-100A is a Times Microwave 50-ohm flexible coaxial cable with a 0.100" outer diameter, delivering significantly lower signal loss than RG-174 or RG-178 at the same form factor. Its foil-plus-braid shield offers 40 dB shielding effectiveness. A popular upgrade for short antenna pigtails and module connections in WiFi, cellular, and GPS applications.
What is the signal loss of LMR100 Times?
At 1800 MHz, LMR100 Times has approximately 23.8 dB of loss per 100 ft (0.238 dB/ft).
What frequency range does this assembly support?
This assembly is rated DC – 300 MHz, limited by the lowest-rated component across the cable and connectors.
What is a F connector?
The F connector is a low-cost threaded coaxial connector used almost exclusively in cable TV, satellite, and over-the-air broadcast applications. It uses the center conductor of RG-6 or RG-59 cable as the pin, which simplifies termination and reduces cost. F connectors are found on cable modems, satellite receivers, TV tuners, and distribution amplifiers.
