Cable
LMR100 Times
End A
F FEMALE
$2.00
End B
RP-TNC MALE
$1.00
LMR100 Times — F FEMALE to RP-TNC MALE
Custom LMR100 Times cable assembly with F FEMALE and RP-TNC MALE connectors. Every cable is hand-assembled, tested, and ships free.
| Length | Price | |
|---|---|---|
| 1 ft | $11.50 | |
| 6 ft | $16.50 | |
| 25 ft | $35.50 | |
| 50 ft | $60.50 | |
| 100 ft | $110.50 |
Specs Summary
About This Assembly
LMR100 Times Cable
LMR-100A is a Times Microwave 50-ohm flexible coaxial cable with a 0.100" outer diameter, delivering significantly lower signal loss than RG-174 or RG-178 at the same form factor. Its foil-plus-braid shield offers 40 dB shielding effectiveness. A popular upgrade for short antenna pigtails and module connections in WiFi, cellular, and GPS applications.
F Connector
The F connector is a low-cost threaded coaxial connector used almost exclusively in cable TV, satellite, and over-the-air broadcast applications. It uses the center conductor of RG-6 or RG-59 cable as the pin, which simplifies termination and reduces cost. F connectors are found on cable modems, satellite receivers, TV tuners, and distribution amplifiers.
RP-TNC Connector
RP-TNC (Reverse Polarity TNC) uses the TNC threaded shell with reversed pin conventions, similar to RP-SMA. It is used on some commercial WiFi access points and outdoor CPE antennas, particularly in older Cisco and Linksys equipment, and offers better vibration resistance than RP-SMA in demanding outdoor environments.
Common Applications
This F and RP-TNC cable assembly is well suited for short antenna pigtails, module-to-antenna connections, and compact RF assemblies. The combination of reliable F and RP-TNC connectors and custom-cut cable length makes it a practical choice for both field installations and bench setups. Every assembly is hand-terminated, continuity tested, and ships free within the USA.
