LMR240 ULTRA FLEX Times cable

Cable

LMR240 ULTRA FLEX Times

N FEMALE

End A

N FEMALE

PL259 UHF Male

End B

PL259 UHF Male

Specs Summary

CableLMR240 ULTRA FLEX Times
Diameter.240 INCH
Impedance50 Ohm
FrequencyDC – 300 MHz
Length6 ft
Velocity Factor84%
N FEMALE InterfaceType N threaded (MIL-STD-348)
PL259 UHF Male InterfaceUHF threaded (PL-259 / SO-239)
50 Ohm DC – 300 MHz

6 ft LMR240 ULTRA FLEX Times — N FEMALE to PL259 UHF Male

LMR240 ULTRA FLEX Times cable assembly, 6 feet, with N FEMALE and PL259 UHF Male connectors. Hand-assembled, tested, and ships free within the US.

6 ft — N FEMALE / PL259 UHF Male

$37.43

Free shipping • In stock

Need a different length? Use the Cable Builder

Signal Loss — 6 ft

Approximate insertion loss for this 6 ft LMR240 ULTRA FLEX Times assembly at common RF frequencies.

Frequency Loss / 100 ft Loss — 6 ft
100 MHz 2.5 dB 0.15 dB
450 MHz 5.5 dB 0.33 dB
900 MHz 7.8 dB 0.47 dB
1.8 GHz 11.2 dB 0.67 dB
2.4 GHz 13.1 dB 0.79 dB
5.8 GHz 21.5 dB 1.29 dB

About This Assembly

LMR240 ULTRA FLEX Times Cable

LMR-240-UltraFlex is the ultra-flexible variant of LMR-240 from Times Microwave, sharing the same electrical performance but with a stranded center conductor and softer jacket that makes it significantly easier to route. Preferred for mobile radio installs, vehicle-mounted antennas, and any application with tight bends or frequent cable movement.

N Connector

Type N is a threaded RF connector rated from DC to 18 GHz with a durable weatherproof design, making it the preferred interface for outdoor antenna installations, cellular base stations, and commercial wireless infrastructure. Its larger size compared to SMA allows higher power handling and the threaded coupling resists vibration, making it suitable for mobile and fixed outdoor applications.

UHF Connector

The UHF connector (also known as PL-259 male / SO-239 female) is a large, low-cost RF connector designed in the 1930s for HF and VHF frequencies. Despite its name, its practical usable range is below 300 MHz due to its non-constant impedance design. It remains extremely popular in amateur radio (HF through VHF), CB radio, and marine radio applications.

Common Applications

This N and UHF cable assembly is well suited for vehicle-mounted radio installations, tight-routing applications, and mobile platforms. The combination of reliable N and UHF connectors and custom-cut cable length makes it a practical choice for both field installations and bench setups. Every assembly is hand-terminated, continuity tested, and ships free within the USA.

Frequently Asked Questions

Is this cable hand-assembled in the USA?

Yes. Every CoaxRF cable assembly is hand-terminated and continuity tested at our US facility before shipping. We do not drop-ship pre-made cables from overseas — each cable is built to order.

Can I order a different length than 6 ft?

Yes. This page is for the 6 ft assembly. Use the length buttons above to select a different standard length, or use the Cable Builder for any custom length.

How much signal loss will I see with this 6 ft cable?

At 1800 MHz, LMR240 ULTRA FLEX Times loses approximately 11.2 dB per 100 ft. This 6 ft assembly will have roughly 0.67 dB of insertion loss at that frequency. See the signal loss table for all frequency points.

What is the maximum frequency for this assembly?

This assembly is rated DC – 300 MHz. The effective frequency limit is set by the lowest-rated component — either the cable or one of the connectors. Both N FEMALE and PL259 UHF Male connectors must be within spec at your target frequency.

What is your return policy?

We accept returns within 30 days of delivery. Custom-length cables are accepted as long as they are in original condition. Contact us and we will provide a prepaid return label at no charge.

Other LMR240 ULTRA FLEX Times Configurations