LMR240 ULTRA FLEX Times cable

Cable

LMR240 ULTRA FLEX Times

SMA FEMALE

End A

SMA FEMALE

SMA FEMALE

End B

SMA FEMALE

Specs Summary

CableLMR240 ULTRA FLEX Times
Diameter.240 INCH
Impedance50 Ohm
FrequencyDC – 6 GHz
Length1 ft
Velocity Factor84%
SMA FEMALE InterfaceSMA threaded (MIL-STD-348)
SMA FEMALE InterfaceSMA threaded (MIL-STD-348)
50 Ohm DC – 6 GHz

1 ft LMR240 ULTRA FLEX Times — SMA FEMALE to SMA FEMALE

LMR240 ULTRA FLEX Times cable assembly, 1 feet, with SMA FEMALE and SMA FEMALE connectors. Hand-assembled, tested, and ships free within the US.

1 ft — SMA FEMALE / SMA FEMALE

$22.98

Free shipping • In stock

Need a different length? Use the Cable Builder

Signal Loss — 1 ft

Approximate insertion loss for this 1 ft LMR240 ULTRA FLEX Times assembly at common RF frequencies.

Frequency Loss / 100 ft Loss — 1 ft
100 MHz 2.5 dB 0.03 dB
450 MHz 5.5 dB 0.06 dB
900 MHz 7.8 dB 0.08 dB
1.8 GHz 11.2 dB 0.11 dB
2.4 GHz 13.1 dB 0.13 dB
5.8 GHz 21.5 dB 0.22 dB

About This Assembly

LMR240 ULTRA FLEX Times Cable

LMR-240-UltraFlex is the ultra-flexible variant of LMR-240 from Times Microwave, sharing the same electrical performance but with a stranded center conductor and softer jacket that makes it significantly easier to route. Preferred for mobile radio installs, vehicle-mounted antennas, and any application with tight bends or frequent cable movement.

SMA Connector

SMA (SubMiniature version A) is the most widely used RF connector in the industry, offering a threaded interface that provides a secure, low-reflection connection from DC to 18 GHz. Its compact size, 50-ohm impedance, and broad frequency range make it the default choice for WiFi equipment, software-defined radios, cellular antennas, GPS receivers, and RF test instruments.

Common Applications

This SMA cable assembly is well suited for vehicle-mounted radio installations, tight-routing applications, and mobile platforms. The combination of reliable SMA connectors and custom-cut cable length makes it a practical choice for both field installations and bench setups. Every assembly is hand-terminated, continuity tested, and ships free within the USA.

Frequently Asked Questions

Is this cable hand-assembled in the USA?

Yes. Every CoaxRF cable assembly is hand-terminated and continuity tested at our US facility before shipping. We do not drop-ship pre-made cables from overseas — each cable is built to order.

Can I order a different length than 1 ft?

Yes. This page is for the 1 ft assembly. Use the length buttons above to select a different standard length, or use the Cable Builder for any custom length.

How much signal loss will I see with this 1 ft cable?

At 1800 MHz, LMR240 ULTRA FLEX Times loses approximately 11.2 dB per 100 ft. This 1 ft assembly will have roughly 0.11 dB of insertion loss at that frequency. See the signal loss table for all frequency points.

What is the maximum frequency for this assembly?

This assembly is rated DC – 6 GHz. The effective frequency limit is set by the lowest-rated component — either the cable or one of the connectors. Both SMA FEMALE and SMA FEMALE connectors must be within spec at your target frequency.

What is your return policy?

We accept returns within 30 days of delivery. Custom-length cables are accepted as long as they are in original condition. Contact us and we will provide a prepaid return label at no charge.

Other LMR240 ULTRA FLEX Times Configurations