Cable
RFC100A
End A
F MALE
$2.00
End B
RP-TNC MALE
$1.00
RFC100A — F MALE to RP-TNC MALE
Custom RFC100A cable assembly with F MALE and RP-TNC MALE connectors. Every cable is hand-assembled, tested, and ships free.
| Length | Price | |
|---|---|---|
| 1 ft | $8.99 | |
| 6 ft | $13.49 | |
| 25 ft | $30.59 | |
| 50 ft | $53.09 | |
| 100 ft | $98.09 |
Specs Summary
About This Assembly
RFC100A Cable
RFC-100A is a cost-effective thin 50-ohm coaxial cable equivalent in size to LMR-100A, offering solid performance for short internal connections and pigtails at a lower price point. A practical choice for budget-conscious builds where cable runs are under 10 feet, such as WiFi module connections, GPS pigtails, and compact RF assemblies.
F Connector
The F connector is a low-cost threaded coaxial connector used almost exclusively in cable TV, satellite, and over-the-air broadcast applications. It uses the center conductor of RG-6 or RG-59 cable as the pin, which simplifies termination and reduces cost. F connectors are found on cable modems, satellite receivers, TV tuners, and distribution amplifiers.
RP-TNC Connector
RP-TNC (Reverse Polarity TNC) uses the TNC threaded shell with reversed pin conventions, similar to RP-SMA. It is used on some commercial WiFi access points and outdoor CPE antennas, particularly in older Cisco and Linksys equipment, and offers better vibration resistance than RP-SMA in demanding outdoor environments.
Common Applications
This F and RP-TNC cable assembly is well suited for short pigtails and budget compact RF device connections. The combination of reliable F and RP-TNC connectors and custom-cut cable length makes it a practical choice for both field installations and bench setups. Every assembly is hand-terminated, continuity tested, and ships free within the USA.
