Cable
RFC195
End A
RP-SMA MALE
$1.00
End B
SMA MALE
$1.00
RFC195 — RP-SMA MALE to SMA MALE
Custom RFC195 cable assembly with RP-SMA MALE and SMA MALE connectors. Every cable is hand-assembled, tested, and ships free.
| Length | Price | |
|---|---|---|
| 1 ft | $8.99 | |
| 6 ft | $14.74 | |
| 25 ft | $36.59 | |
| 50 ft | $65.34 | |
| 100 ft | $122.84 | |
| 250 ft | $295.34 |
Specs Summary
About This Assembly
RFC195 Cable
RFC-195 is a budget-friendly 50-ohm coaxial cable with a 0.195" outer diameter that provides good performance for short-to-medium runs at a lower price than LMR-195. Suitable for antenna jumpers, two-way radio leads, and WiFi access point connections up to 30 feet where cost efficiency is the primary consideration.
RP-SMA Connector
RP-SMA (Reverse Polarity SMA) uses the SMA threaded coupling mechanism but with the male/female pin convention reversed — the jack has a pin and the plug has a socket. Originally standardized to prevent connection of uncertified antennas to consumer WiFi equipment, RP-SMA is now the dominant connector on commercial WiFi routers, access points, and 2.4/5 GHz antennas.
SMA Connector
SMA (SubMiniature version A) is the most widely used RF connector in the industry, offering a threaded interface that provides a secure, low-reflection connection from DC to 18 GHz. Its compact size, 50-ohm impedance, and broad frequency range make it the default choice for WiFi equipment, software-defined radios, cellular antennas, GPS receivers, and RF test instruments.
Common Applications
This RP-SMA and SMA cable assembly is well suited for short-to-medium antenna jumpers and budget wireless installations. The combination of reliable RP-SMA and SMA connectors and custom-cut cable length makes it a practical choice for both field installations and bench setups. Every assembly is hand-terminated, continuity tested, and ships free within the USA.
