RFC400 ULTRA FLEX cable

Cable

RFC400 ULTRA FLEX

PL259 UHF Male

End A

PL259 UHF Male

SO239 UHF Female

End B

SO239 UHF Female

Specs Summary

CableRFC400 ULTRA FLEX
Diameter.400 INCH
Impedance50 Ohm
FrequencyDC – 300 MHz
Length250 ft
Velocity Factor83%
PL259 UHF Male InterfaceUHF threaded (PL-259 / SO-239)
SO239 UHF Female InterfaceUHF threaded (PL-259 / SO-239)
50 Ohm DC – 300 MHz

250 ft RFC400 ULTRA FLEX — PL259 UHF Male to SO239 UHF Female

RFC400 ULTRA FLEX cable assembly, 250 feet, with PL259 UHF Male and SO239 UHF Female connectors. Hand-assembled, tested, and ships free within the US.

250 ft — PL259 UHF Male / SO239 UHF Female

$449.68

Free shipping • In stock

Need a different length? Use the Cable Builder

Signal Loss — 250 ft

Approximate insertion loss for this 250 ft RFC400 ULTRA FLEX assembly at common RF frequencies.

Frequency Loss / 100 ft Loss — 250 ft
100 MHz 1.6 dB 4 dB
450 MHz 3.5 dB 8.75 dB
900 MHz 5 dB 12.5 dB
1.8 GHz 7.2 dB 18 dB
2.4 GHz 8.4 dB 21 dB
5.8 GHz 13.8 dB 34.5 dB

About This Assembly

RFC400 ULTRA FLEX Cable

RFC-400-UltraFlex combines the low-loss performance of 0.400" coax with the flexibility needed for complex routing, offering an economical option for installations that benefit from increased bendability. Suitable for rooftop antenna runs, equipment room patch cables, and mobile installs where budget and flexibility are both priorities.

UHF Connector

The UHF connector (also known as PL-259 male / SO-239 female) is a large, low-cost RF connector designed in the 1930s for HF and VHF frequencies. Despite its name, its practical usable range is below 300 MHz due to its non-constant impedance design. It remains extremely popular in amateur radio (HF through VHF), CB radio, and marine radio applications.

Common Applications

This UHF cable assembly is well suited for flexible outdoor antenna runs and budget-conscious mobile installations. The combination of reliable UHF connectors and custom-cut cable length makes it a practical choice for both field installations and bench setups. Every assembly is hand-terminated, continuity tested, and ships free within the USA.

Frequently Asked Questions

Is this cable hand-assembled in the USA?

Yes. Every CoaxRF cable assembly is hand-terminated and continuity tested at our US facility before shipping. We do not drop-ship pre-made cables from overseas — each cable is built to order.

Can I order a different length than 250 ft?

Yes. This page is for the 250 ft assembly. Use the length buttons above to select a different standard length, or use the Cable Builder for any custom length.

How much signal loss will I see with this 250 ft cable?

At 1800 MHz, RFC400 ULTRA FLEX loses approximately 7.2 dB per 100 ft. This 250 ft assembly will have roughly 18 dB of insertion loss at that frequency. See the signal loss table for all frequency points.

What is the maximum frequency for this assembly?

This assembly is rated DC – 300 MHz. The effective frequency limit is set by the lowest-rated component — either the cable or one of the connectors. Both PL259 UHF Male and SO239 UHF Female connectors must be within spec at your target frequency.

What is your return policy?

We accept returns within 30 days of delivery. Custom-length cables are accepted as long as they are in original condition. Contact us and we will provide a prepaid return label at no charge.

Other RFC400 ULTRA FLEX Configurations