Specifications
F MALE Connector
F Family
The F connector is a low-cost threaded coaxial connector used almost exclusively in cable TV, satellite, and over-the-air broadcast applications. It uses the center conductor of RG-6 or RG-59 cable as the pin, which simplifies termination and reduces cost. F connectors are found on cable modems, satellite receivers, TV tuners, and distribution amplifiers.
Typical Applications
Cable TV, satellite TV, over-the-air HDTV, cable modems, distribution amplifiers, TV tuners.
Gender & Polarity Note
Check the product datasheet for gender and polarity details. RF connectors are available in male (pin), female (socket), and reverse-polarity (RP) variants.
Cables Available with F MALE
Select a cable type to see all connector pairings and pricing.
1.13
1.13MM • DC – 6 GHz
RG178
1.75MM • DC – 3 GHz
RG174
.1 INCH • DC – 3 GHz
RG316
.1 INCH • DC – 6 GHz
RFC100A
.1 INCH • DC – 6 GHz
RFC195
.195 INCH • DC – 6 GHz
RG58
.195 INCH • DC – 1 GHz
LMR195 Times
.195 INCH • DC – 6 GHz
RG142
.195 INCH • DC – 6 GHz
RG400
.195 INCH • DC – 6 GHz
RG316DS
.1 INCH • DC – 6 GHz
LMR100 Times
.1 INCH • DC – 6 GHz
1.37
1.37MM • DC – 6 GHz
RGU178
.06 INCH • DC – 6 GHz
Frequently Asked Questions
What frequency range does the F MALE connector support?
F connectors are rated DC – 2 GHz. The effective upper frequency of a cable assembly is limited by the lowest-rated component — either the cable or the connector. Always verify both are within spec for your target frequency.
How many times can a F connector be mated and unmated?
F MALE connectors are rated for approximately 500 mating cycles. Exceeding this can cause wear on the contact surfaces, increasing insertion loss and VSWR. For applications with very frequent connects and disconnects, consider a connector rated for higher cycle counts.
What torque should I use to tighten a F connector?
Use a torque wrench and follow the connector manufacturer's recommended torque specification. Hand-tight plus a quarter turn is a safe starting point for most push-on connectors.
Are the F connectors on CoaxRF assemblies weatherproof?
Our standard cable assemblies use high-quality connectors suitable for most indoor and sheltered outdoor applications. For fully weatherproof outdoor installations, we recommend applying self-amalgamating tape over the connector junction to prevent moisture ingress.
Do CoaxRF cables with F MALE connectors ship assembled and tested?
Yes. Every cable assembly — including those terminated with F MALE connectors — is hand-assembled and continuity tested before shipping. Cables ship free within the US from our US facility.