Cable
1.13
End A
RP-TNC MALE
$1.00
End B
SO239 UHF Female
$3.00
1.13 — RP-TNC MALE to SO239 UHF Female
Custom 1.13 cable assembly with RP-TNC MALE and SO239 UHF Female connectors. Every cable is hand-assembled, tested, and ships free.
| Length | Price | |
|---|---|---|
| 1 ft | $13.19 | |
| 6 ft | $14.79 |
Specs Summary
About This Assembly
1.13 Cable
1.13mm coaxial cable is an ultra-miniature 50-ohm cable used primarily for internal RF wiring in compact wireless devices such as laptops, tablets, and embedded modules. Its extremely small 1.13mm outer diameter allows it to pass through tight spaces inside consumer electronics, connecting antennas to WiFi or cellular modules with minimal signal loss over short distances.
RP-TNC Connector
RP-TNC (Reverse Polarity TNC) uses the TNC threaded shell with reversed pin conventions, similar to RP-SMA. It is used on some commercial WiFi access points and outdoor CPE antennas, particularly in older Cisco and Linksys equipment, and offers better vibration resistance than RP-SMA in demanding outdoor environments.
UHF Connector
The UHF connector (also known as PL-259 male / SO-239 female) is a large, low-cost RF connector designed in the 1930s for HF and VHF frequencies. Despite its name, its practical usable range is below 300 MHz due to its non-constant impedance design. It remains extremely popular in amateur radio (HF through VHF), CB radio, and marine radio applications.
Common Applications
This RP-TNC and UHF cable assembly is well suited for internal WiFi and cellular module antenna connections in laptops and tablets. The combination of reliable RP-TNC and UHF connectors and custom-cut cable length makes it a practical choice for both field installations and bench setups. Every assembly is hand-terminated, continuity tested, and ships free within the USA.
1.13 Signal Loss
Approximate attenuation at common RF frequencies.
| Frequency | Loss / 100 ft | Loss / ft |
|---|---|---|
| 100 MHz | 8.5 dB | 0.085 dB |
| 450 MHz | 18 dB | 0.18 dB |
| 900 MHz | 26 dB | 0.26 dB |
| 1.8 GHz | 38 dB | 0.38 dB |
| 2.4 GHz | 44 dB | 0.44 dB |
| 5.8 GHz | 72 dB | 0.72 dB |
Frequently Asked Questions
What is 1.13 coaxial cable used for?
1.13mm coaxial cable is an ultra-miniature 50-ohm cable used primarily for internal RF wiring in compact wireless devices such as laptops, tablets, and embedded modules. Its extremely small 1.13mm outer diameter allows it to pass through tight spaces inside consumer electronics, connecting antennas to WiFi or cellular modules with minimal signal loss over short distances.
What is the signal loss of 1.13?
At 1800 MHz, 1.13 has approximately 38 dB of loss per 100 ft (0.38 dB/ft).
What frequency range does this assembly support?
This assembly is rated DC – 300 MHz, limited by the lowest-rated component across the cable and connectors.
What is a RP-TNC connector?
RP-TNC (Reverse Polarity TNC) uses the TNC threaded shell with reversed pin conventions, similar to RP-SMA. It is used on some commercial WiFi access points and outdoor CPE antennas, particularly in older Cisco and Linksys equipment, and offers better vibration resistance than RP-SMA in demanding outdoor environments.
