Cable
LMR100 Times
End A
F MALE
End B
SMA FEMALE
Specs Summary
6 ft LMR100 Times — F MALE to SMA FEMALE
LMR100 Times cable assembly, 6 feet, with F MALE and SMA FEMALE connectors. Hand-assembled, tested, and ships free within the US.
6 ft — F MALE / SMA FEMALE
$22.49
Free shipping • In stock
Other lengths:
Signal Loss — 6 ft
Approximate insertion loss for this 6 ft LMR100 Times assembly at common RF frequencies.
| Frequency | Loss / 100 ft | Loss — 6 ft |
|---|---|---|
| 100 MHz | 5.1 dB | 0.31 dB |
| 450 MHz | 11.2 dB | 0.67 dB |
| 900 MHz | 16.2 dB | 0.97 dB |
| 1.8 GHz | 23.8 dB | 1.43 dB |
| 2.4 GHz | 27.8 dB | 1.67 dB |
| 5.8 GHz | 46 dB | 2.76 dB |
About This Assembly
LMR100 Times Cable
LMR-100A is a Times Microwave 50-ohm flexible coaxial cable with a 0.100" outer diameter, delivering significantly lower signal loss than RG-174 or RG-178 at the same form factor. Its foil-plus-braid shield offers 40 dB shielding effectiveness. A popular upgrade for short antenna pigtails and module connections in WiFi, cellular, and GPS applications.
F Connector
The F connector is a low-cost threaded coaxial connector used almost exclusively in cable TV, satellite, and over-the-air broadcast applications. It uses the center conductor of RG-6 or RG-59 cable as the pin, which simplifies termination and reduces cost. F connectors are found on cable modems, satellite receivers, TV tuners, and distribution amplifiers.
SMA Connector
SMA (SubMiniature version A) is the most widely used RF connector in the industry, offering a threaded interface that provides a secure, low-reflection connection from DC to 18 GHz. Its compact size, 50-ohm impedance, and broad frequency range make it the default choice for WiFi equipment, software-defined radios, cellular antennas, GPS receivers, and RF test instruments.
Common Applications
This F and SMA cable assembly is well suited for short antenna pigtails, module-to-antenna connections, and compact RF assemblies. The combination of reliable F and SMA connectors and custom-cut cable length makes it a practical choice for both field installations and bench setups. Every assembly is hand-terminated, continuity tested, and ships free within the USA.
Frequently Asked Questions
Is this cable hand-assembled in the USA?
Yes. Every CoaxRF cable assembly is hand-terminated and continuity tested at our US facility before shipping. We do not drop-ship pre-made cables from overseas — each cable is built to order.
Can I order a different length than 6 ft?
Yes. This page is for the 6 ft assembly. Use the length buttons above to select a different standard length, or use the Cable Builder for any custom length.
How much signal loss will I see with this 6 ft cable?
At 1800 MHz, LMR100 Times loses approximately 23.8 dB per 100 ft. This 6 ft assembly will have roughly 1.43 dB of insertion loss at that frequency. See the signal loss table for all frequency points.
What is the maximum frequency for this assembly?
This assembly is rated DC – 2 GHz. The effective frequency limit is set by the lowest-rated component — either the cable or one of the connectors. Both F MALE and SMA FEMALE connectors must be within spec at your target frequency.
What is your return policy?
We accept returns within 30 days of delivery. Custom-length cables are accepted as long as they are in original condition. Contact us and we will provide a prepaid return label at no charge.
