LMR195 Times cable

Cable

LMR195 Times

F FEMALE

End A

F FEMALE

TNC FEMALE

End B

TNC FEMALE

Specs Summary

CableLMR195 Times
Diameter.195 INCH
Impedance50 Ohm
FrequencyDC – 2 GHz
Length25 ft
Velocity Factor83%
F FEMALE InterfaceF-type threaded
TNC FEMALE InterfaceTNC threaded (MIL-STD-348)
50 Ohm DC – 2 GHz

25 ft LMR195 Times — F FEMALE to TNC FEMALE

LMR195 Times cable assembly, 25 feet, with F FEMALE and TNC FEMALE connectors. Hand-assembled, tested, and ships free within the US.

25 ft — F FEMALE / TNC FEMALE

$54.50

Free shipping • In stock

Need a different length? Use the Cable Builder

Signal Loss — 25 ft

Approximate insertion loss for this 25 ft LMR195 Times assembly at common RF frequencies.

Frequency Loss / 100 ft Loss — 25 ft
100 MHz 3.3 dB 0.83 dB
450 MHz 7.1 dB 1.78 dB
900 MHz 10.2 dB 2.55 dB
1.8 GHz 14.9 dB 3.72 dB
2.4 GHz 17.3 dB 4.33 dB
5.8 GHz 28.9 dB 7.23 dB

About This Assembly

LMR195 Times Cable

LMR-195 is a Times Microwave 50-ohm flexible coaxial cable with a 0.195" outer diameter and very low loss compared to RG-58. Its aluminized tape plus tinned copper braid shield provides excellent 40 dB shielding, making it suitable for runs from 10 to 50 feet in WiFi, cellular, and two-way radio installations.

F Connector

The F connector is a low-cost threaded coaxial connector used almost exclusively in cable TV, satellite, and over-the-air broadcast applications. It uses the center conductor of RG-6 or RG-59 cable as the pin, which simplifies termination and reduces cost. F connectors are found on cable modems, satellite receivers, TV tuners, and distribution amplifiers.

TNC Connector

TNC (Threaded Neill–Concelman) is the threaded version of BNC, offering improved performance up to 11 GHz and better vibration resistance through its screw coupling. It is commonly used in mobile radio antennas, avionics, and outdoor installations where BNC's bayonet lock would not provide sufficient mechanical security.

Common Applications

This F and TNC cable assembly is well suited for WiFi antenna pigtails, cellular signal boosters, and two-way radio connections. The combination of reliable F and TNC connectors and custom-cut cable length makes it a practical choice for both field installations and bench setups. Every assembly is hand-terminated, continuity tested, and ships free within the USA.

Frequently Asked Questions

Is this cable hand-assembled in the USA?

Yes. Every CoaxRF cable assembly is hand-terminated and continuity tested at our US facility before shipping. We do not drop-ship pre-made cables from overseas — each cable is built to order.

Can I order a different length than 25 ft?

Yes. This page is for the 25 ft assembly. Use the length buttons above to select a different standard length, or use the Cable Builder for any custom length.

How much signal loss will I see with this 25 ft cable?

At 1800 MHz, LMR195 Times loses approximately 14.9 dB per 100 ft. This 25 ft assembly will have roughly 3.72 dB of insertion loss at that frequency. See the signal loss table for all frequency points.

What is the maximum frequency for this assembly?

This assembly is rated DC – 2 GHz. The effective frequency limit is set by the lowest-rated component — either the cable or one of the connectors. Both F FEMALE and TNC FEMALE connectors must be within spec at your target frequency.

What is your return policy?

We accept returns within 30 days of delivery. Custom-length cables are accepted as long as they are in original condition. Contact us and we will provide a prepaid return label at no charge.

Other LMR195 Times Configurations