Cable
RFC100A
End A
F MALE
End B
SMA FEMALE
Specs Summary
50 ft RFC100A — F MALE to SMA FEMALE
RFC100A cable assembly, 50 feet, with F MALE and SMA FEMALE connectors. Hand-assembled, tested, and ships free within the US.
50 ft — F MALE / SMA FEMALE
$59.08
Free shipping • In stock
Other lengths:
Signal Loss — 50 ft
Approximate insertion loss for this 50 ft RFC100A assembly at common RF frequencies.
| Frequency | Loss / 100 ft | Loss — 50 ft |
|---|---|---|
| 100 MHz | 5.3 dB | 2.65 dB |
| 450 MHz | 11.5 dB | 5.75 dB |
| 900 MHz | 16.5 dB | 8.25 dB |
| 1.8 GHz | 24.5 dB | 12.25 dB |
| 2.4 GHz | 29 dB | 14.5 dB |
| 5.8 GHz | 49 dB | 24.5 dB |
About This Assembly
RFC100A Cable
RFC-100A is a cost-effective thin 50-ohm coaxial cable equivalent in size to LMR-100A, offering solid performance for short internal connections and pigtails at a lower price point. A practical choice for budget-conscious builds where cable runs are under 10 feet, such as WiFi module connections, GPS pigtails, and compact RF assemblies.
F Connector
The F connector is a low-cost threaded coaxial connector used almost exclusively in cable TV, satellite, and over-the-air broadcast applications. It uses the center conductor of RG-6 or RG-59 cable as the pin, which simplifies termination and reduces cost. F connectors are found on cable modems, satellite receivers, TV tuners, and distribution amplifiers.
SMA Connector
SMA (SubMiniature version A) is the most widely used RF connector in the industry, offering a threaded interface that provides a secure, low-reflection connection from DC to 18 GHz. Its compact size, 50-ohm impedance, and broad frequency range make it the default choice for WiFi equipment, software-defined radios, cellular antennas, GPS receivers, and RF test instruments.
Common Applications
This F and SMA cable assembly is well suited for short pigtails and budget compact RF device connections. The combination of reliable F and SMA connectors and custom-cut cable length makes it a practical choice for both field installations and bench setups. Every assembly is hand-terminated, continuity tested, and ships free within the USA.
Frequently Asked Questions
Is this cable hand-assembled in the USA?
Yes. Every CoaxRF cable assembly is hand-terminated and continuity tested at our US facility before shipping. We do not drop-ship pre-made cables from overseas — each cable is built to order.
Can I order a different length than 50 ft?
Yes. This page is for the 50 ft assembly. Use the length buttons above to select a different standard length, or use the Cable Builder for any custom length.
How much signal loss will I see with this 50 ft cable?
At 1800 MHz, RFC100A loses approximately 24.5 dB per 100 ft. This 50 ft assembly will have roughly 12.25 dB of insertion loss at that frequency. See the signal loss table for all frequency points.
What is the maximum frequency for this assembly?
This assembly is rated DC – 2 GHz. The effective frequency limit is set by the lowest-rated component — either the cable or one of the connectors. Both F MALE and SMA FEMALE connectors must be within spec at your target frequency.
What is your return policy?
We accept returns within 30 days of delivery. Custom-length cables are accepted as long as they are in original condition. Contact us and we will provide a prepaid return label at no charge.
