Cable
RFC195
End A
PL259 UHF Male
$3.00
End B
RP-TNC MALE
$1.00
RFC195 — PL259 UHF Male to RP-TNC MALE
Custom RFC195 cable assembly with PL259 UHF Male and RP-TNC MALE connectors. Every cable is hand-assembled, tested, and ships free.
| Length | Price | |
|---|---|---|
| 1 ft | $10.99 | |
| 6 ft | $16.74 | |
| 25 ft | $38.59 | |
| 50 ft | $67.34 | |
| 100 ft | $124.84 | |
| 250 ft | $297.34 |
Specs Summary
About This Assembly
RFC195 Cable
RFC-195 is a budget-friendly 50-ohm coaxial cable with a 0.195" outer diameter that provides good performance for short-to-medium runs at a lower price than LMR-195. Suitable for antenna jumpers, two-way radio leads, and WiFi access point connections up to 30 feet where cost efficiency is the primary consideration.
UHF Connector
The UHF connector (also known as PL-259 male / SO-239 female) is a large, low-cost RF connector designed in the 1930s for HF and VHF frequencies. Despite its name, its practical usable range is below 300 MHz due to its non-constant impedance design. It remains extremely popular in amateur radio (HF through VHF), CB radio, and marine radio applications.
RP-TNC Connector
RP-TNC (Reverse Polarity TNC) uses the TNC threaded shell with reversed pin conventions, similar to RP-SMA. It is used on some commercial WiFi access points and outdoor CPE antennas, particularly in older Cisco and Linksys equipment, and offers better vibration resistance than RP-SMA in demanding outdoor environments.
Common Applications
This RP-TNC and UHF cable assembly is well suited for short-to-medium antenna jumpers and budget wireless installations. The combination of reliable RP-TNC and UHF connectors and custom-cut cable length makes it a practical choice for both field installations and bench setups. Every assembly is hand-terminated, continuity tested, and ships free within the USA.
