Cable
RG174
End A
F FEMALE
End B
SMA MALE
Specs Summary
25 ft RG174 — F FEMALE to SMA MALE
RG174 cable assembly, 25 feet, with F FEMALE and SMA MALE connectors. Hand-assembled, tested, and ships free within the US.
25 ft — F FEMALE / SMA MALE
$29.80
Free shipping • In stock
Other lengths:
Signal Loss — 25 ft
Approximate insertion loss for this 25 ft RG174 assembly at common RF frequencies.
| Frequency | Loss / 100 ft | Loss — 25 ft |
|---|---|---|
| 100 MHz | 6.6 dB | 1.65 dB |
| 450 MHz | 14.5 dB | 3.62 dB |
| 900 MHz | 21.5 dB | 5.38 dB |
| 1.8 GHz | 32 dB | 8 dB |
| 2.4 GHz | 38 dB | 9.5 dB |
| 5.8 GHz | 65 dB | 16.25 dB |
About This Assembly
RG174 Cable
RG-174 is an ultra-thin, highly flexible 50-ohm coaxial cable with a 0.100" outer diameter — one of the smallest coax types available. Its stranded center conductor and single-braid shield make it ideal for tight internal wiring where space is at a premium. Typical uses include GPS antenna pigtails, WiFi module connections, and short adapter leads inside enclosures.
F Connector
The F connector is a low-cost threaded coaxial connector used almost exclusively in cable TV, satellite, and over-the-air broadcast applications. It uses the center conductor of RG-6 or RG-59 cable as the pin, which simplifies termination and reduces cost. F connectors are found on cable modems, satellite receivers, TV tuners, and distribution amplifiers.
SMA Connector
SMA (SubMiniature version A) is the most widely used RF connector in the industry, offering a threaded interface that provides a secure, low-reflection connection from DC to 18 GHz. Its compact size, 50-ohm impedance, and broad frequency range make it the default choice for WiFi equipment, software-defined radios, cellular antennas, GPS receivers, and RF test instruments.
Common Applications
This F and SMA cable assembly is well suited for GPS and WiFi module pigtails, short flexible adapter leads, and internal device wiring. The combination of reliable F and SMA connectors and custom-cut cable length makes it a practical choice for both field installations and bench setups. Every assembly is hand-terminated, continuity tested, and ships free within the USA.
Frequently Asked Questions
Is this cable hand-assembled in the USA?
Yes. Every CoaxRF cable assembly is hand-terminated and continuity tested at our US facility before shipping. We do not drop-ship pre-made cables from overseas — each cable is built to order.
Can I order a different length than 25 ft?
Yes. This page is for the 25 ft assembly. Use the length buttons above to select a different standard length, or use the Cable Builder for any custom length.
How much signal loss will I see with this 25 ft cable?
At 1800 MHz, RG174 loses approximately 32 dB per 100 ft. This 25 ft assembly will have roughly 8 dB of insertion loss at that frequency. See the signal loss table for all frequency points.
What is the maximum frequency for this assembly?
This assembly is rated DC – 2 GHz. The effective frequency limit is set by the lowest-rated component — either the cable or one of the connectors. Both F FEMALE and SMA MALE connectors must be within spec at your target frequency.
What is your return policy?
We accept returns within 30 days of delivery. Custom-length cables are accepted as long as they are in original condition. Contact us and we will provide a prepaid return label at no charge.
