1.13 — FME FEMALE to RP-TNC MALE
Cable
1.13
End A
FME FEMALE
$2.00
End B
RP-TNC MALE
$1.00
Specs Summary
1.13 — FME FEMALE to RP-TNC MALE
Made in USA
About This Assembly
Specs Summary
1.13 Cable
1.13mm coaxial cable is an ultra-miniature 50-ohm cable used primarily for internal RF wiring in compact wireless devices such as laptops, tablets, and embedded modules. Its extremely small 1.13mm outer diameter allows it to pass through tight spaces inside consumer electronics, connecting antennas to WiFi or cellular modules with minimal signal loss over short distances.
FME Connector
FME (For Mobile Equipment) is a miniature threaded RF connector designed for mobile and vehicle-mounted antenna applications, particularly at GSM, CDMA, and FM frequencies. Its small size and robust threaded coupling make it common on vehicle-mount antenna mounts, cellular signal boosters, and mobile broadband modems.
RP-TNC Connector
RP-TNC (Reverse Polarity TNC) uses the TNC threaded shell with reversed pin conventions, similar to RP-SMA. It is used on some commercial WiFi access points and outdoor CPE antennas, particularly in older Cisco and Linksys equipment, and offers better vibration resistance than RP-SMA in demanding outdoor environments.
Common Applications
This FME and RP-TNC cable assembly is well suited for internal WiFi and cellular module antenna connections in laptops and tablets. The combination of reliable FME and RP-TNC connectors and custom-cut cable length makes it a practical choice for both field installations and bench setups. Every assembly is hand-terminated, continuity tested, and ships free within the USA.
1.13 Signal Loss
Approximate attenuation at common RF frequencies.
| Frequency | Loss / 100 ft | Loss / ft |
|---|---|---|
| 100 MHz | 8.5 dB | 0.085 dB |
| 450 MHz | 18 dB | 0.18 dB |
| 900 MHz | 26 dB | 0.26 dB |
| 1.8 GHz | 38 dB | 0.38 dB |
| 2.4 GHz | 44 dB | 0.44 dB |
| 5.8 GHz | 72 dB | 0.72 dB |
Frequently Asked Questions
What is 1.13 coaxial cable used for?
1.13mm coaxial cable is an ultra-miniature 50-ohm cable used primarily for internal RF wiring in compact wireless devices such as laptops, tablets, and embedded modules. Its extremely small 1.13mm outer diameter allows it to pass through tight spaces inside consumer electronics, connecting antennas to WiFi or cellular modules with minimal signal loss over short distances.
What is the signal loss of 1.13?
At 1800 MHz, 1.13 has approximately 38 dB of loss per 100 ft (0.38 dB/ft).
What frequency range does this assembly support?
This assembly is rated DC – 2 GHz, limited by the lowest-rated component across the cable and connectors.
What is a FME connector?
FME (For Mobile Equipment) is a miniature threaded RF connector designed for mobile and vehicle-mounted antenna applications, particularly at GSM, CDMA, and FM frequencies. Its small size and robust threaded coupling make it common on vehicle-mount antenna mounts, cellular signal boosters, and mobile broadband modems.
