Cable
LMR195 Times
End A
F MALE
End B
MCX MALE
Specs Summary
50 ft LMR195 Times — F MALE to MCX MALE
LMR195 Times cable assembly, 50 feet, with F MALE and MCX MALE connectors. Hand-assembled, tested, and ships free within the US.
50 ft — F MALE / MCX MALE
$91.50
Free shipping • In stock
Other lengths:
Signal Loss — 50 ft
Approximate insertion loss for this 50 ft LMR195 Times assembly at common RF frequencies.
| Frequency | Loss / 100 ft | Loss — 50 ft |
|---|---|---|
| 100 MHz | 3.3 dB | 1.65 dB |
| 450 MHz | 7.1 dB | 3.55 dB |
| 900 MHz | 10.2 dB | 5.1 dB |
| 1.8 GHz | 14.9 dB | 7.45 dB |
| 2.4 GHz | 17.3 dB | 8.65 dB |
| 5.8 GHz | 28.9 dB | 14.45 dB |
About This Assembly
LMR195 Times Cable
LMR-195 is a Times Microwave 50-ohm flexible coaxial cable with a 0.195" outer diameter and very low loss compared to RG-58. Its aluminized tape plus tinned copper braid shield provides excellent 40 dB shielding, making it suitable for runs from 10 to 50 feet in WiFi, cellular, and two-way radio installations.
F Connector
The F connector is a low-cost threaded coaxial connector used almost exclusively in cable TV, satellite, and over-the-air broadcast applications. It uses the center conductor of RG-6 or RG-59 cable as the pin, which simplifies termination and reduces cost. F connectors are found on cable modems, satellite receivers, TV tuners, and distribution amplifiers.
MCX Connector
MCX (Micro Coaxial) is a snap-on RF connector approximately 30% smaller than SMB, designed for compact equipment requiring frequent connections in a small footprint. Rated to 6 GHz, MCX is commonly used in GPS receivers, automotive telematics modules, handheld communication devices, and compact measurement instruments.
Common Applications
This F and MCX cable assembly is well suited for WiFi antenna pigtails, cellular signal boosters, and two-way radio connections. The combination of reliable F and MCX connectors and custom-cut cable length makes it a practical choice for both field installations and bench setups. Every assembly is hand-terminated, continuity tested, and ships free within the USA.
Frequently Asked Questions
Is this cable hand-assembled in the USA?
Yes. Every CoaxRF cable assembly is hand-terminated and continuity tested at our US facility before shipping. We do not drop-ship pre-made cables from overseas — each cable is built to order.
Can I order a different length than 50 ft?
Yes. This page is for the 50 ft assembly. Use the length buttons above to select a different standard length, or use the Cable Builder for any custom length.
How much signal loss will I see with this 50 ft cable?
At 1800 MHz, LMR195 Times loses approximately 14.9 dB per 100 ft. This 50 ft assembly will have roughly 7.45 dB of insertion loss at that frequency. See the signal loss table for all frequency points.
What is the maximum frequency for this assembly?
This assembly is rated DC – 2 GHz. The effective frequency limit is set by the lowest-rated component — either the cable or one of the connectors. Both F MALE and MCX MALE connectors must be within spec at your target frequency.
What is your return policy?
We accept returns within 30 days of delivery. Custom-length cables are accepted as long as they are in original condition. Contact us and we will provide a prepaid return label at no charge.
