Cable
RFC195
End A
F FEMALE
$2.00
End B
SMA MALE
$1.00
RFC195 — F FEMALE to SMA MALE
Custom RFC195 cable assembly with F FEMALE and SMA MALE connectors. Every cable is hand-assembled, tested, and ships free.
| Length | Price | |
|---|---|---|
| 1 ft | $15.98 | |
| 6 ft | $21.73 | |
| 25 ft | $43.58 | |
| 50 ft | $72.33 | |
| 100 ft | $129.83 | |
| 250 ft | $302.33 |
Specs Summary
About This Assembly
RFC195 Cable
RFC-195 is a budget-friendly 50-ohm coaxial cable with a 0.195" outer diameter that provides good performance for short-to-medium runs at a lower price than LMR-195. Suitable for antenna jumpers, two-way radio leads, and WiFi access point connections up to 30 feet where cost efficiency is the primary consideration.
F Connector
The F connector is a low-cost threaded coaxial connector used almost exclusively in cable TV, satellite, and over-the-air broadcast applications. It uses the center conductor of RG-6 or RG-59 cable as the pin, which simplifies termination and reduces cost. F connectors are found on cable modems, satellite receivers, TV tuners, and distribution amplifiers.
SMA Connector
SMA (SubMiniature version A) is the most widely used RF connector in the industry, offering a threaded interface that provides a secure, low-reflection connection from DC to 18 GHz. Its compact size, 50-ohm impedance, and broad frequency range make it the default choice for WiFi equipment, software-defined radios, cellular antennas, GPS receivers, and RF test instruments.
Common Applications
This F and SMA cable assembly is well suited for short-to-medium antenna jumpers and budget wireless installations. The combination of reliable F and SMA connectors and custom-cut cable length makes it a practical choice for both field installations and bench setups. Every assembly is hand-terminated, continuity tested, and ships free within the USA.
RFC195 Signal Loss
Approximate attenuation at common RF frequencies.
| Frequency | Loss / 100 ft | Loss / ft |
|---|---|---|
| 100 MHz | 3.3 dB | 0.033 dB |
| 450 MHz | 7.2 dB | 0.072 dB |
| 900 MHz | 10.4 dB | 0.104 dB |
| 1.8 GHz | 15.1 dB | 0.151 dB |
| 2.4 GHz | 17.7 dB | 0.177 dB |
| 5.8 GHz | 29.4 dB | 0.294 dB |
Frequently Asked Questions
What is RFC195 coaxial cable used for?
RFC-195 is a budget-friendly 50-ohm coaxial cable with a 0.195" outer diameter that provides good performance for short-to-medium runs at a lower price than LMR-195. Suitable for antenna jumpers, two-way radio leads, and WiFi access point connections up to 30 feet where cost efficiency is the primary consideration.
What is the signal loss of RFC195?
At 1800 MHz, RFC195 has approximately 15.1 dB of loss per 100 ft (0.151 dB/ft).
What frequency range does this assembly support?
This assembly is rated DC – 2 GHz, limited by the lowest-rated component across the cable and connectors.
What is a F connector?
The F connector is a low-cost threaded coaxial connector used almost exclusively in cable TV, satellite, and over-the-air broadcast applications. It uses the center conductor of RG-6 or RG-59 cable as the pin, which simplifies termination and reduces cost. F connectors are found on cable modems, satellite receivers, TV tuners, and distribution amplifiers.
